Skip to content
PermitRoadmap

Do I need a permit for fence installation or replacement in Brunswick?

Permit may be required

It depends. Whether fence installation or replacement needs a permit in Brunswick comes down to the details of your project.

Georgia has no statewide list of work exempt from a building permit. The Georgia amendments to the 2024 International Residential Code delete Chapter 1, Scope and Administration, without substitution, and keep it in the code only as a reference and guide for local governments developing their own administrative procedures. The 7 foot fence line that Chapter 1 contains is therefore a model figure, not a Georgia rule. Permit thresholds for fences in Georgia are set by each local government. Many jurisdictions require a zoning or land-use approval for a fence of any height, and apply their own limits on front-yard height, corner sight triangles and which side the finished face must face, so confirm the local rule. Pool barrier fences are a separate matter and must meet the code height, gate and latch requirements regardless of any local fence-permit threshold. Glynn County's own permitting office is the Glynn County Building Permitting and Inspections office, reachable on 912-554-7456 at https://www.glynncounty.org/government/departments/building-permitting-inspections. It issues permits for the unincorporated county. If your city does not run its own building department, and many smaller Georgia municipalities do not, this is the office that will handle the job. Fences are usually a zoning review rather than a building permit, and the zoning office may be separate from the building office. The Brunswick FAQ lists fences not over 7 feet high as exempt from a building permit. Under Code section 23-3-23, on a corner lot no fence or wall may block driver vision between three and ten feet above street level within 25 feet of where the street right-of-way lines meet. In the historic district, staff may approve back and side yard fences on lots that are not corner lots, and a front yard wood picket fence no more than 42 inches high with no trellis or arbor. Other fences go to the Historic Preservation Board.

Documents you may need

  • Permit or fence applicationSometimes required
  • Site plan / plat showing fence location and property linesLikely required
  • Fence height and material detailsSometimes required
  • City of Brunswick Building Permit Application for fences over 7 feetSometimes required
  • Certificate of Appropriateness (Old Town Brunswick Historic Preservation District)Sometimes required

Possible inspections

  • Final / zoning compliance inspection where a permit is required
  • Final inspection where a permit is issued

Frequently asked questions

Do I need a permit for fence installation or replacement in Brunswick?
It depends. Whether fence installation or replacement needs a permit in Brunswick comes down to the details of your project. The documents and inspections sections on this page list what the building department typically asks for.
Who issues the permit in Brunswick?
The local building department for Brunswick handles permitting. This page lists its contact details and online portal. Your mailing city is not always the permitting authority, so confirm the jurisdiction before you apply.
How do I find out the exact requirements for my project?
Run the free PermitRoadmap check for your specific project and answers. It returns the likely permits, documents, inspections, and next steps, each linked to its official source.

PermitRoadmap is an independent informational service and is not affiliated with any city, county, state agency, or permitting authority. Results are informational and do not replace confirming requirements with the local permitting authority.