Do I need a permit for pavers, driveway, or hardscape in Holly Springs?

It depends. Whether pavers, driveway, or hardscape needs a permit in Holly Springs comes down to the details of your project.

Ground-level patios, walkways and driveways of pavers commonly fall under the NCGS 160D-1110(c) cost test and may not need a building permit, but added impervious surface can trigger stormwater, watershed or zoning review in many North Carolina jurisdictions. Confirm before you begin. A raised deck or any electrical for landscape lighting requires its own permit and is not exempt, because both are named exceptions to the cost test. Most North Carolina departments treat a retaining wall as structural work above a set height, commonly 4 feet or any height where the wall supports a surcharge. North Carolina publishes no statewide work-exempt list, so that figure comes from the model residential code rather than from state law. Confirm the height your inspections department uses. Wake County's own permitting office is Wake County Permits and Inspections. It issues permits for the unincorporated county, and in North Carolina the county is often the building authority even inside city limits, so confirm which applies to your address. Erosion control here depends on which town you are in. Wake County administers erosion control for all unincorporated areas plus six municipalities under interlocal agreements: Garner, Knightdale, Morrisville, Wendell, Rolesville and Zebulon. If you are in one of those six, or in the unincorporated county, your plan goes to Wake County. Raleigh, Cary, Apex and the other Wake towns run their own programs. A long driveway or extensive hardscape adds both disturbance and built-upon area, so confirm before ordering material. The trigger is size, not cost: Wake County reviews construction plans for land development over one acre of disturbance. Ordinary single-family work is normally well under that, so this bites on large lots, big site regrading, or a project combined with substantial clearing.