Do I need a permit for roof replacement or repair in Juno Beach?
Yes. In Florida, roof replacement or repair generally requires a permit, and Juno Beach is no exception.
Florida requires a permit to replace or recover a roof, and most repairs above a small area also need one. Under the Florida 25 percent rule, if 25 percent or more of a roof section is repaired or replaced within 12 months, that section must be brought up to the current Florida Building Code. The roofing system usually needs Florida Product Approval.
Local detail for Juno Beach: Permit fees payable online via MGO; in person at Town Center cash or check only.
Florida and local notes for Juno Beach
Palm Beach County's own permitting office is the Palm Beach County Planning, Zoning & Building Department (Building Division), reachable on 561-233-5100 at https://discover.pbc.gov/pzb/pages/contact-us.aspx. Its online permit portal is https://pbc.gov/epzb. It issues permits for the unincorporated county. If your city does not run its own building department, this is the office that will handle the job. Palm Beach County is a high-wind area. The county's own amendments set ultimate design wind speeds ranging from 140 to 180 mph 3-second gust for Exposure Category C, depending on the Risk Category assigned to the building. All of unincorporated Palm Beach County is in the wind-borne debris region. Inside a municipality the exact wind speed and debris region lines are set by local ordinance, so confirm the figure for your parcel rather than assuming. Roof coverings, underlayment and fasteners are designed to the county wind speed for your parcel, and product approval documentation is expected with the application. Because there are eight wind speed lines across the Risk Categories with no clean physical landmarks between them, the county publishes a separate GIS tool per Risk Category on its Building Division site. Use it to get the design wind speed for your specific parcel before ordering materials or commissioning drawings.
Documents you may need
- Permit applicationLikely required
- Licensed roofing contractor informationLikely required
- Product approval (FL number or NOA) for the roofing systemLikely required
- Notice of commencement (for work over the statutory value)Sometimes required
- Permit application (if above the local repair threshold)Sometimes required
- Florida Product Approval or Miami-Dade NOA for impact rated productsSometimes required
- Wind load design pressures for components and claddingSometimes required
Possible inspections
- Sheathing and nailing inspection
- Dry-in (underlayment) inspection
- Final inspection
Frequently asked questions
- Do I need a permit for roof replacement or repair in Juno Beach?
- Yes. In Florida, roof replacement or repair generally requires a permit, and Juno Beach is no exception. The documents and inspections sections on this page list what the building department typically asks for.
- Who issues the permit in Juno Beach?
- The local building department for Juno Beach handles permitting. This page lists its contact details and online portal. Your mailing city is not always the permitting authority, so confirm the jurisdiction before you apply.
- How do I find out the exact requirements for my project?
- Run the free PermitRoadmap check for your specific project and answers. It returns the likely permits, documents, inspections, and next steps, each linked to its official source.
PermitRoadmap is an independent informational service and is not affiliated with any city, county, state agency, or permitting authority. Results are informational and do not replace confirming requirements with the local permitting authority.