Do I need a permit for roof replacement or repair in Littleton?
Yes. In Colorado, roof replacement or repair generally requires a permit, and Littleton is no exception.
Because Colorado has no statewide building code, whether a reroof needs a permit and which IRC edition applies is set by your city or county, but most jurisdictions require a building permit to re-cover or tear off a roof. In mountain and foothill areas, roofs must meet local snow-load design and, in wildland-urban-interface zones, ignition-resistant (often Class A) roof-covering rules; confirm both with your building department before choosing materials. Littleton treats removing or replacing more than 100 square feet (one square) of roof covering in aggregate as a roof replacement that needs a permit, and asphalt, metal, and tile roofs beyond a repair require full replacement with tear-off to the deck. No overlays are accepted. An ASTM D1970 ice and water barrier is required at the eaves of all conditioned structures, extending at least 24 inches inside the exterior wall line, and at least 36 inches along the slope on roofs of 8:12 or steeper. Littleton's design criteria are a 40 psf ground snow load and a 136 mph wind speed. Asphalt shingles must be ASTM D7158 Class H with at least six nails per shingle, and need a 2:12 minimum slope with double underlayment or ice barrier up to 4:12. Spaced or board sheathing with any gap over 1/2 inch must be overlaid or replaced with at least 3/8 inch panel sheathing. For roof inspections, provide a ladder rated for at least 250 pounds that extends 3 feet above the eave, set and secured, and a roof free of rain, frost, ice, and snow.
Documents you may need
- Permit applicationRequired
- Scope of work (tear-off vs overlay, roof covering type)Required
- Product/underlayment specifications for the new roof assemblySometimes required
- eTRAKiT re-roof permit application, obtained before work starts and displayed where visible from the streetRequired
- Scope of work covering materials, squares, and any sheathing replacement or overlayRequired
- Manufacturer specifications for the roof covering, submitted at permit intakeRequired
- City of Littleton contractor license for any roofer you hireLikely required
- Remove-and-replace permit from a city-licensed solar contractor if the home has a solar systemSometimes required
Possible inspections
- Sheathing/nailing (dry-in) inspection where required
- Final roof inspection
- Sheathing fastening inspection before underlayment or roofing is installed, when sheathing is replaced or overlaid
- Final roof inspection to close the permit
Frequently asked questions
- Do I need a permit for roof replacement or repair in Littleton?
- Yes. In Colorado, roof replacement or repair generally requires a permit, and Littleton is no exception. The documents and inspections sections on this page list what the building department typically asks for.
- Who issues the permit in Littleton?
- The local building department for Littleton handles permitting. This page lists its contact details and online portal. Your mailing city is not always the permitting authority, so confirm the jurisdiction before you apply.
- How do I find out the exact requirements for my project?
- Run the free PermitRoadmap check for your specific project and answers. It returns the likely permits, documents, inspections, and next steps, each linked to its official source.
PermitRoadmap is an independent informational service and is not affiliated with any city, county, state agency, or permitting authority. Results are informational and do not replace confirming requirements with the local permitting authority.